HANNspree XV Series 32 Flat Panel Television User Manual


 
15
When you enter this control, the screen below will be displayed.
The factory default of the password is “0000”.
To enable parental control, input the password, press button to focus on OK key, and press
ENTER. (select Cancel if you want to exit)
After entering, the following screen will be shown.
Channel Lock: To lock channels. Use ◄► to select the channel you want to lock, and then
press ENTER to lock or unlock it.
Change Password: To change the password, press ENTER and enter the
password again. Press ENTER, and the following screen appears.
Enter the new password, use to move the cursor down, and then enter the new password
again, press OK to confirm or Cancel to exit.
Note: Please make sure you remember your new password after changing, because you cannot
recall the default setting of the password by any selection.
Clear All: To clear all the locks set before, press ENTER.
Press MENU to return to the previous page.
Color Temperature: To select the color temperature from Warm, Cold, Normal or User. (If you
select User, you can adjust the degree of R, G, B in Color Temp. to suit your personal
preference.)
Back Light: To adjust the luminance of the back light.
Aspect Ratio: To select image size between Normal, Full, Wide1, Wide2, Wide3,
4:3, 16:9, and No scale.
OSD Timeout: To setup the display time of OSD. (5, 15, 45, and 60 seconds)
Memory Recall: To restore the factory default settings.
English