Filter
Top Products
Page 2For technical questions, please call 1-800-444-3353.SKU 67781
ASSEMBLY AND MOUNTING
Read the ENTIRE IMPORTANT SAFETY
INFORMATION section at the beginning
of this document including all text under
subheadings therein before set up or use
of this product.
NOTE: The following tools (none supplied)
are required for mounting and installation:
Stud Finder, 11/16” socket, ratchet handle,
#2 Phillips screwdriver, 1/4” drill bit (for
drilling into wood stud), 1/2” masonry drill bit
(for drilling into brick or concrete wall), and
minimum 6” level, 5mm hex wrench, and
10mm combination wrench.
Before Installing
Use the 5mm hex wrench to double-check that 1.
all four socket screws of the Wall Bracket (1) are
tight. Tighten any connection, if needed.
Set Wall Bracket against the wall at the desired 2.
height. Place a level over the upper or lower
cross bar and adjust Bracket until level. Use a
marker to indicate locations of mounting holes.
Attaching to Wood Studs
First, verify woods studs are at least 16” apart. 1.
Use a Stud Finder (not included) to nd two
adjacent studs 16” apart. Use a marker to
indicate locations of the studs.
Drill four 1/4” holes at least 3-1/2” deep into the 2.
studs at the marked spots.
Use Lag Bolts (10) and Washers (9) to mount 3.
Wall Bracket to wall. See Figure 1, below.
Attaching to Brick or Concrete Wall
NOTE: 1. Verify at least 6” of space are between
any two holes. Use 1/2” carbide tip masonry drill
bit and drill four 3-3/8” deep holes.
Insert the Wall Anchors (11) into the holes, 2.
making sure they are ush with the wall surface.
WARNING! 3. Wall Anchors must be set rmly
against concrete or masonry. If mounting to
a masonry wall covered with drywall/plaster,
counter bore a hole through drywall/plaster
around mounting holes’ locations. This will allow
Wall Anchors to be set directly against concrete
or masonry. See Figures 2a and 2b, below.
Once Wall Anchors are securely set into 4.
concrete, use Lag Bolts and Washers to install
Wall Bracket to wall. See Figure 3, below.
Attaching to Metal Studs or Concrete
Block Wall
NOTE: 1. If mounting to steel stud wall or cinder
block wall, alternative mounting hardware is
required.
Installing Support Arms to Flat Panel TV
WARNING! 1. Verify TV is unplugged before
threading any Screw into the TV’s back panel.
Concrete
Wall
Anchor (11)
Washer
(9)
Lag
Bolt (10)
Wall Bracket (1)
Figure 2a
Figure 2b
Wall
Anchor (11)
Concrete
Wall
Bracket
(1)
Lag
Bolt
(10)
Plaster/
Drywall
Wall
Bracket
(1)
Lag Bolt (11) and Washer (10)
Wall Anchor (12)
Figure 3
Lag Bolt (10) and Washer (9)
Wall
Bracket
(1)
Figure 1