Filter
Top Products
Setting Up the TV32
Turning Off the TV
• Press the power button on the TV.
or
• On the remote control, press Device until TV is selected, and then press the power button.
The internal fans continue to run for a short time during the cool-down period. Even though the TV is off, it
uses a small amount of power internally.
CAUTION: Do not disconnect power until the TV has cooled and the fan stops running—up to three
minutes after turning it off. Otherwise, you might shorten the life of the lamp.
If you turn on the TV again during the cool-down period, the TV might not turn on as quickly as normal.
Completing the Basic Setup
Finding Your Channels
After you connect your cable and antenna sources, you are ready to find the available channels on those
sources. These are the channels you can receive on the TV tuner using the Ch+ and Ch– buttons.
TIP: If you have a cable box or satellite receiver, you must set up that device to view channels from that
source. The TV tuner receives channels from only the antenna and cable inputs.
NOTE: The following steps can take from one minute up to 30 minutes or more.
If you have an antenna connected to the antenna input:
1. On the remote control, press Settings and go to Setup > Channel setup > Auto search antenna, and
then press OK.
2. Wait for the TV to scan all channels available from the antenna.
If you have cable service connected to the cable input:
1. Press Settings and go to Setup > Channel setup > Cable service. Ask your cable provider if either HRC
or IRC is used and, if so, change this setting accordingly. For most cable providers, use the standard
setting.
2. On the remote control, press Settings and go to Setup > Channel setup > Auto search cable, and then
press OK.
3. Wait for the TV to scan all channels.
After all channels are found, you can manually add or remove channels from the list. See “Adding or
Deleting a Channel” on page 51.
Downloaded from www.Manualslib.com manuals search engine