Filter
Top Products
SCART arrangement 2
Pin Signal Signal level Impedance
1 Audio output B (right) 0.5V rms <1kohm
2 Audio input B (right) 0.5V rms >10kohm
3 Audio output A (left) 0.5V rms <1kohm
4 Ground (audio) - -
5 Ground - -
6 Audio input A (left) 0.5V rms >10kohm
7 - - -
8
9 Ground - -
10
11 - - -
12
13 Ground - -
14 Ground (blanking) - -
15
16 - - -
17 Ground (video input & output)- -
18 - - -
19 Video output (composite) 1V including sync 75ohms
20
21 Common ground (shield) - -
Appendix
Innovation is life
-17 -
-
-
-
Function select (AV control)
- -
-
---
>10kohm
WARNING: Do NOT attempt to work on ANY equipment unless you KNOW what you are doing.
When scart1 or scart2 is pluged in, do not connect S-video and video from TV back
Cleaning and care
WARNING: Do not try to remove the cabinet back. Refer servicing to qualified service technicians.
To clean the TV screen:
1) Unplug the TV to avoid possible shock hazard.
2) Use a clean cellulose sponge or chamois cloth dampened with a solution of mild detergent and warm
water to clean the TV screen and trim. Do not use too much water as water spilled into the cabinet
can cause damage to the TV.
3) Wipe off any excess moisture with a clean dry cloth.
4) Polish the cabinet with a quality furniture polish to maintain the finish and appearance of the cabinet.
Caution: Never use strong solvents such as thinner, benzene, or other chemicals on or near the cabinet.
These chemicals can damage the finish of the cabinet.
High (9.5-12V) - AV mode
Low (0-2V) - TV mode
1V including sync
75ohms
Video input (composite)