Hisense Group PDP4211EU Flat Panel Television User Manual


 
Specifications
RF system: B/G, D/K, I, L/L
Colour system: PAL, SECAM, NTSC(only for AV)
Channel coverage: VHF Low channel (VL)= 48.25 to 160.00 MHz
VHF high channel (VH)= 160.00 to 442.00 MHz
UHF channel( U)= 442.00 to 863.25 MHz
Power supply: AC 100~240V, 50/60Hz
Power consumption: 390W
Audio output: 7W+7W
Connection interface: RF input: 1 CATV RF antenna input
Video input: 1 AV input
1 S-terminal (Y/C component) input
1 Y Cb Cr / Y Pb Pr input
Graphic input: 1 analog RGB D-SUB 15pin input
Audio input: 1 AV audio
1 PC audio
1 RS232C input interface for software updating
Dimension: 1043mm 640mm 85mm
Weight: 32.5kg
Accessories
Speaker Impedance: 8
Panel Resolution: 852(W)*480(H)
Scart: Scart1
Scart2
Remote control Batteries S cable CATV cable Power cord User's manual
Desktop Stand Speakers Wall mounting bracket(optional)
,
CUSTOMER NOTICE: IMPORTANT
Displaying a still picture for a long time will cause fluorescent burning which means permanent damage to
the screen. Therefore, do NOT display the same picture on the screen for more than 10 minutes! This
product has auto-pixel-shift protection to alleviate the burning effect. Yet, this protection will NOT avoid
fluorescent burning completely.
Operate carefully to prevent damage to the screen.
Cleaning and Care
WARNING: TV sets use high voltage. Do not try to remove the cabinet back. Refer servicing to qualified
service technicians.
To clean the TV screen:
1) Unplug the TV to avoid possible shock hazard.
2) Use a clean cellulose sponge or chamois cloth dampened with a solution of mild detergent and warm
water to clean the TV screen and trim. Do not use too much water because water spills into the cabinet
can cause damage to the TV.
3) Wipe off any excess moisture with a clean dry cloth.
4)Polish the cabinet with a quality furniture polish to maintain the finish and appearance of the cabinet.
Caution: Never use strong solvents such as thinner, benzene, or other chemicals on or near the cabinet.
These chemicals can damage the finish of the cabinet.
-15-