Hitachi 22LD4550C Flat Panel Television User Manual


  Open as PDF
of 78
 
24
ENGLISH
Connecting with a HDMI to DVI cable
Connect the DVI output of the PC to the
HDMI IN 1(DVI) jack on the TV.
Connect the PC audio output to the
AUDIO IN (RGB/DVI) jack on the TV.
Turn on the PC and the TV.
Select HDMI1 input source using the
INPUT button on the remote control.
NOTE
To enjoy vivid picture and sound, connect a
PC to the TV.
AvoidkeepingaxedimageontheTV’s
screen for prolonged periods of time. The
xedimagemaybecomepermanently
imprintedonthescreen;useascreensaver
when possible.
ConnectthePCtotheRGB(PC)orHDMI
IN(orHDMI/DVIIN)portoftheTV;change
the resolution.
There may be interference relating to
resolution, vertical pattern, contrast or
brightness in PC mode. Change the PC
mode to another resolution or change
the refresh rate to another rate or until
the picture is clear. If the refresh rate of
the PC graphic card can not be changed,
change the PC graphic card or consult the
manufacturer of the PC graphic card.
The synchronization input waveform for
HorizontalandVerticalfrequenciesare
separate.
Connect the signal cable from the monitor
outputportofthePCtotheRGB(PC)port
of the TV or the signal cable from the HDMI
output port of the PC to the HDMI IN (or
HDMI/DVI IN) port on the TV.
Connect the audio cable from the PC to the
Audio input on the TV. (Audio cables are not
included with the TV).
If using a sound card, adjust PC sound as
required.
This TV uses a VESA Plug and Play
Solution. The TV provides EDID data to the
PC system with a DDC protocol. The PC
adjusts automatically when using this TV.
DDCprotocolispresetforRGB(Analog
RGB),HDMI(DigitalRGB)mode.
Ifrequired,adjustthesettingsforPlugand
Play functionality.
If the graphic card on the PC does not output
analogueanddigitalRGBsimultaneously,
connectonlyoneofeitherRGBorHDMIIN
(or HDMI/DVI IN) to display the PC output on
the TV.
If the graphic card on the PC does output
analogueanddigitalRGBsimultaneously,
switchtheTVtoeitherRGBorHDMI;
(the other mode is set to Plug and Play
automatically by the TV.)
DOS mode may not work depending on the
video card if you use a HDMI to DVI cable.
Forbestpicturequality,usinganRGB-PC
cable under 5m is recommended.
AUDIO IN
(RGB/DVI)
HDMI IN 1
(DVI)
 previous next