Filter
Top Products
OPERATION OF REMOTE CONTROL
38
• All VCR buttons will operate whether the Remote Control is in TV or CATV modes.
• For detailed information on the use of the VCR, refer to the operation manual of the VCR.
click here for image
VCR POWER
PLAY
REWING
PAUSE II
STOP
REMOTE KEYPAD
ENTER
FF
VCR CHANNEL
UP (
) / DOWN ( )
RECORD
•
HOW TO IDENTIFY A VCR
The remote control may already be set to operate your VCR. Try this initial check to see if going on to the
following "identify" section is necessary.
(1) Point remote towards VCR and press VCR POWER.
(2) Does the remote turn the VCR ON and OFF?
• If yes, the remote is ready to operate the VCR and no further steps are needed.
• If no, continue to the "identify" section.
TO IDENTIFY YOUR VCR - DIRECT ENTRY METHOD
Use the following steps and list to quickly find the remote control code for your accessory VCR.
• First look up your VCR's remote control code number (page 35) before going through the direct code entry steps
control.
• If this procedure does not identify your accessory VCR, use the Search method of identification (described in the
next section).
(1) Slide TV-CATV switch to TV.
(2) Press and hold down RECALL and CH DOWN (
) on your remote control.