Hitachi 28LD5000TA Flat Panel Television User Manual


 
31
ENGLISH
OPERATING INSTRUCTIONS (continued)
PinP button
D / N
A / B
i
+
MENU
OK
FREEZE
ZOOM
2-4-12
I / II
P+
P-
+-
DVD
123
456
78
0
9
RECALL button
The input signal status can be displayed on the screen
by pressing the RECALL button of the remote control.
The display will go out in approximately 6 seconds.
AV1
Composite
-- -- Min.
-- -- : -- --
OFF
ON
Input Signal Screen Display
Input mode
Signal mode
Off-timer
On-timer
VIDEO
Displaying MULTI PICTURE
If the PinP button on the remote control is pressed MULTI
PICTURE will display.
Activating the P-in-P mode from the RGB input screen
Pressing the PinP button one time will display 2 pictures.
This mode can be available from RGB1(DVI-PC) and RGB2(RGB)
input.
The speaker icon can be shifted left and right by pressing the A/B
button; the audio of the video will be output from the side on which
the speaker icon is located.
The sub-screen position can be
selected up and down by pressing
SELECT buttons.
The sub-screen can be selected with
the AV1, AV2, AV3, and AV4 buttons
from the status that the speaker icon
appears on the left side of AVas
shown in the diagram to the right.
Pressing the PinP button again or the RETURN button will cancel
the 2 pictures display.
"Frequency Mode" in the Setup Menu should be set to Movie when
sub-screen is the component signal of 1080i/50 or 1080i/60.
AV1: Displays the VIDEO input signal of the sub-screen.
Activating the Split mode from the video input screen
Pressing the PinP button one
time will display 2 pictures.
The speaker icon can be shifted left
and right by pressing the A/B
button; the audio of the video will be
output from the side on which the
speaker icon is located.
The same video input mode cannot
be selected for both screens at the
same time.
Pressing the PinP button again or the RETURN button will cancel
the 2 pictures display.
When the Video input is set to RGB Video, this Split mode is not possible.
Refer to the table for 2 pictures (Split) mode.
RGB2
AV1
(Sub-
screen)
AV1 AV2
2 Pictures (Split)
Main Sub
NOTE
Even if the input of the horizontal / vertical synchronizing signal (or video signal) stops in the MULTI PICTURE display, the mode will not
change to power save mode.
Please be careful since image retention will occur if display is left in a MULTI PICTURE display state for a long period of time.
Input terminal AV1~AV4 AV1, AV2 RGB1 RGB2
PAL
SECAM
NTSC3.58
NTSC4.43
576i
576p
480i
480p
1080i/50 1080i/60 720p/60 STB Component
AV1
~AV4
PAL, SECAM
NTSC3.58/4.43
AV1
AV2
576i, 576p
480i, 480p
1080i/50
1080i/60
720p/60
RGB1 STB
RGB2 Component
(
: Available)
Main
Sub
A/B button
SELECT button