Filter
Top Products
-SET UP- FUNCTIONS
Refer to your cable or TV guide for channel identification standards.
If certain CATV channels are poor or not possible in the CATV mode, set the -
AIR/CABLE- select to CATV2.
• AUTOPROGRAM
This feature will automatically store active TV channels in CHANNEL MEMORY. This
will allow you to skip over unused channels when using the CHANNEL UP ( ) or
DOWN ( ) buttons.
If the MENU button is pressed while the autoprogramming function is engaged,
programming will stop.
See CHANNEL MEMORY to add or erase additional channels.
• CHANNEL MEMORY
Use this function after AUTOPROGRAM to add or erase additional channels to the
remote control CHANNEL , buttons.
Add or erase additional channels while still in CHANNEL MEMORY using the
CHANNEL
, buttons or number buttons and then add or erase using the CURSOR
, buttons.
• CLOCK SET
Use the same remote control buttons as shown in previous examples to display the
clock setting, press MENU, 1, ENTER, 2, ENTER, 4, ENTER.
Once the proper time is set (including AM or PM), press MENU to start.
• CHANNEL CAPTION
Use this feature to give channel names to up to 24 channels for the antenna source