Filter
Top Products
23
ENGLISH
BASIC OPERATION (continued)
Input Switching to TV/AV1~5, HDMI, and RGB
By pressing Input Select button, you can switch the input. (DTT input: 9700 models only)
T
o watch actual broadcast, press Input Select button on the control panel,
the numeric buttons or Channel Up/Down button on the remote control.
To display the image outputting from the external equipments
connected to each terminal (DTT / TV, AV1~5, HDMI 1 / 2, and RGB),
select corresponding mode.
1. Press Input Select button on the remote control.
2. The Input modes can be also switched by using Input Select button
on the control panel.
Each time this button is pressed, the screen displays corresponding
mode by following order.
3. To directly go back to TV mode, pressing channel Up/Down button on
either remote control or the control panel.
Also, you can use the numeric buttons on the remote control.
Input Signal Screen Display
The input signal status can be displayed on the screen by pressing the
+
button
of
the remote control. (DTT mode: 9700 models only)
The display in DTT mode will also appear as changing the channels and go out in
approximately 3 seconds. Refer to
44
about the information banner.
The display in TV/Video/RGB mode will go out in approximately 6 seconds.
Channel Up button
Channel Down button
Input Select button
Input Select buttons
Recall
button
Channel
Up/Down button
P
P
SD MEMORY
CARD
PUSH-EJECT
OK
PH35814
AV1
Composite
-- -- Min.
-- -- : -- --
OFF
Off-timer
On-timer
Input mode
Signal mode
VIDEO
RGB
H : 48.4kHz
V : 60.1 Hz
-- -- Min.
-- -- : -- --
OFF
Off-timer
On-timer
Input mode
Input horizontal frequency
Input vertical frequency
RGB
Now: ----
Next: ----
1. ABCDE
-- -- : -- -- - -- -- : -- --
-- -- : -- -- - -- -- : -- --
Signal Level:
-- : --
Broadcasting time
DTT
Programme
name
Channel
name
1
ABCDE
-- -- Min.
-- -- : -- --
OFF
Off-timer
On-timer
TV position
Name
Sound mode
TV
TVDTT AV1 AV2 AV3
AV5HDMI 1HDMI 2RGB
AV4