Filter
Top Products
20
INSTALLATION INSTRUCTIONS (continued)
Connecting to an Audio Visual Device
(1) Make sure that the signal of the audio visual device to be used is compatible with the specifications of this
device. See “PRODUCT SPECIFICATIONS” concerning the specifications of this device. 49 ~ 51
(2) Make sure that the power switch of the PDP TV is turned off.
(3) Make sure that the power switch of the audio visual device is turned off.
(4) Use a commercially available cable and connector to connect the signal input terminal on the rear panel of
this device and the signal output terminal of the audio visual device.
1. Attach a DVB-T antenna cable to the DVB-T terminal.
2. Connect the outdoor antenna cable lead-in to the terminal marked DVB-T
IN on the rear of the TV set.
3. Connect all power sources before activating the PDP TV.
4. Turn on the PDP TV.
5. Press DTT/TV on the remote to choose HDTV mode.
6. When operating the HDTV at first time, please execute “Installation”
menu 39 for normally display.
1. Use an antenna cable connects to an outdoor antenna.
2. Connect all power sources before activating the PDP TV.
3. Turn on the PDP TV.
4. To use the TV, press DTT/TV button on the remote to choose TV mode.
5. When operating the TV at first time, its TV system is at “default
factory mode” and this mode cannot display the image normally
on the screen. In order to watch the TV program without problem,
please execute “TV Channel Setup” menu 33 for normally display.
If there are noise appearance in the picture of VHF-Low band channel, please use the double-shielded cable (not provided) for RF
LEADS to reduce the noise
Precautions when connecting the antenna
‧ Please use a coaxial cable which is free from interference to connect the antenna.
‧ Avoid using a parallel flat feeder wire as interference may occur, causing reception to be unstable and stripe noise to
appear on the screen.
‧ Avoid using indoor antenna as this may be affected by interference. Please use CATV net or outdoor antenna.
‧ Keep the power cord as far away from the antenna wire as possible.
‧ For safet
y
, install an external antenna conformin
g
to AS1417.1
(
a
pp
licable for Australia onl
y)
CONNECTING AN ANALOG TV CABLE OR AN ANALOG ANTENNA WITHOUT A TV CABLE BOX
CONNECTING AN DIGITAL TV ANTENNA