Filter
Top Products
USING THE REMOTE TO CONTROL AUDIO EQUIPMENT FUNCTIONS - 27 -
UP function.
PRECODED FOR CABLE BOX
These buttons transmit the chosen precoded CATV codes.
EXCLUSIVE TV BUTTONS
These buttons are for operating the TV.
Click to see Remote.
USING THE REMOTE TO CONTROL AUDIO EQUIPMENT FUNCTIONS
Operating the pre-coded function for your audio equipment
This remote is designed to operate different types of audio equipment. You must first
program the remote to match the remote system in your audio equipment. (Refer to
page 26)
1. Set the MULTI-PAGE select switch to"AUDIO".
2. Turn ON the audio component you wish to control with your remote (AMP, CD, or
TAPE).
3. Aim the remote control at the front of your audio equipment.
4. While holding down the button on the remote which corresponds with the component
you wish to control (AMP, CD, or TAPE), enter the 2 digit preset code that matches your
audio component as shown on page 26. The remote will turn off your audio component
when the correct 2 digit preset code is entered. When this occurs, the remote control is
programmed for your audio component. If the audio component does not turn off after 5
seconds, try a different 2 digit preset code.
5. The remote will now control your audio component.
6. Repeat steps 2-5 until all audio equipment preset codes are programmed into the
remote.
NOTES:
1. If your audio component cannot be operated after performing the above procedures, this
means that your audio components codes have not been precoded into the remote.
2. In the unlikely event that your audio component cannot operate after performing the
above procedures, consult your audio component operating guide.
3. The remote control will remember the codes you have programmed in until the batteries
are removed from the remote control. After replacing the batteries repeat the entire
programming procedure stated above.
4. If your audio component does not have a power function, the remote will issue another