Filter
Top Products
59
NOTE: This product contains lead and a lamp that contains mercury. Dispose of this product and its lamp in
accordance with applicable environmental laws. For lamp recycling and disposal information, go to
www.lamprecycle.org. For product recycling and disposal information, contact your local government
agency or eRecycle.org (in California), the Electronic Industries Alliance at www.eiae.org (in the US) or
Electronic Product Stewardship Canada atwww.epsc.ca (in Canada).
For more information, call “1-800-Hitachi”.
Lamp Replacement
Lamp Replacement
Hg
6. Without installing the lamp cover, the power will be off and the Lamp Indicator will flash (see page 9). Be sure
to install the lamp cover by re-engaging the two clips and tighten the screws before turning the power on,
otherwise it may cause unusual colors.
NOTE: If power is connected before the Lamp Cover is installed, the power will be off and the Lamp Indicator
will flash (see page 9).
7. Install the front cover as shown below. Put the front cover back in and align the snap on quick connect
then push inwards holding the left and right side of the front cover until you hear a snap. Push the other
snap on gently to make a good fit.
8. Plug power cord into AC outlet and turn on the main power switch.
120V
SCREW
LAMP COVER
PHILLIP HEAD
SCREW DRIVER