Filter
Top Products
28
USING THE REMOTE TO CONTROL
CABLE BOX/SATELLITE FUNCTIONS
NOTES:
1. If your cable/satellite box cannot be operated after performing the above procedures, your cable/satellite boxÕs code has not
been precoded into the remote.
2. In the unlikely event that your cable/satellite box cannot be operated after performing the above procedures, please consult
your cable/satellite boxÕs operating guide.
3. The remote control will remember the codes you have programmed until the batteries are removed from the remote control.
After replacing the batteries repeat the entire programming procedure as stated above.
Operating the precoded function for your cable/satellite box.
This remote is designed to operate different types of cable boxes and satellite systems. You must first program the remote to match
the remote system of your cable/satellite box. (refer to page 29)
1. Turn ON your cable/satellite box.
2. Aim the remote control at the front of your cable/satellite box.
3. Press the CBL/SAT button to switch to the cable/satellite box pre-coded mode.
4. Hold down the CBL/SAT button on the remote, enter the two digit preset code that matches your cable/satellite box as shown
on page 29. The remote will turn off your cable/satellite box when the correct two digit preset code is entered. When this occurs,
the remote control is programmed for your cable/satellite box. If the cable/satellite box does not turn off after five seconds, try
a different two digit preset code.
5. The remote will now control you cable/satellite box.
PRECODED CABLE/SATELLITE Box buttons
These buttons transmit the chosen precoded
CABLE/SATELLITE codes.
123
456
789
0
INPUT
STATUS
VOL CH
POWER
TV CBL/SAT DVD/VCR
PIP
SWAP MOVE
FREEZE
HELP
MENU
MUTE
EXIT
LAST CH
REC
TV/VCR
PIX
SELECT
PIP CH
EXCLUSIVE TV buttons
These buttons are for
operating the TV.
CBL/SAT button
This button allows the remote to
control your cable/satellite box
by setting it to CBL/SAT mode.