Hitachi 50ES1K Projection Television User Manual


 
ANTENNA CONNECTIONS - 11 -
should use 75-Ohm coaxial shielded wire. Cables can be purchased from most stores
that sell audio/video products. Below are illustrations and names of common
connectors.
Before purchasing any cables, be sure of the output and input connector types required
by the various components. Also make sure the cables are the correct length.
300-Ohm Twin Lead Connector "F" Type 75-Ohm Coaxial
This outdoor antenna cable must be connected to Antenna Connector
an antenna adaptor (300-Ohm to 75-Ohm). For connecting RF signals
(antenna or cable
TV) to the antenna jack on the
television.
Phono Connector S-Video (Super Video) Connector
Used on all standard video and audio cables which This connector is used on
camcorders, VCRs,
connect to inputs and outputs located on the and laser disc players with an S-
Video feature
Television's front and rear jack panels. in place of the standard video
cable to produce
a high-quality picture.
ANTENNA CONNECTIONS
VHF (75-) antenna/CATV(cable TV)
When using a 75-ohm coaxial cable system, connect the outdoor antenna or CATV
coaxial cable to the VHF/UHF 75-ohm terminal.
VHF (300-) antenna/UHF antenna
When using a 300-ohm twin lead from an outdoor antenna, disconnect the VHF or UHF
indoor antenna leads from screws of the VHF or UHF adaptor, and connect outdoor
VHF or UHF antenna leads to these screws of the VHF or UHF adaptor.