Hitachi 53SWX10B Projection Television User Manual


 
PICTURE-IN-PICTURE CONT.
SPLIT MODE PIP
Split Mode PIP displays the main picture and sub-picture evenly on the screen.
SURF MODE PIP
This feature will automatically scan all active channel numbers (those set in memory) and display them as PIP sub-pictures, along
the right edge of the screen. Press the PIP button a second time to remove the sub-pictures from the screen.
SWAP button
If you wish to switch what is being shown on the main picture to the sub-picture, press the SWAP button.
28
PICTURE-IN-PICTURE (PIP)
NOTES: 1. If no buttons are pressed when in SURF mode, auto-scanning will continuously scan channels in memory.
(see page 41)
2. If a channel is tuned during this SURF scanning, sub-pictures will be removed from the screen.
3. SURF MODE PIP is allowed only when ANT A is selected as the main channel.
4. If PARENTAL CONTROL MOVIE/TV RATINGS setting is ON, PIP SURF mode will be deactivated.
5. Closed Caption will not appear when PIP SURF mode is on.
NOTES: 1. The SWAP button will only operate in SINGLE/SPLIT PIP mode.
2. The SWAP function will not operate if ANT B input is set as the main channel (ANT B input cannot be displayed as
a sub-picture.)
Ant A 28
Ant A 10
09
10
12
PIP MODE button
To change between the three different PIP modes (SINGLE, SPLIT or SURF) press the PIP MODE button when PIP is ON.
Each press of this button will change PIP to a different mode. Pressing this button three times will cycle through both PIP
modes.
SINGLE
PIP
PIP
SWAP
PIP MODE
PIP MODE
Ant A 10
Ant A 12
Main Picture
Sub Picture
Ant A 10
Ant A 12
Ant A 10
Ant A 10
SWAP
SPLIT
Ant A 12
Ant A 12
Ant A 10
Ant A 10
Ant A 12
Ant A 10
Ant A 12
2
2
3
4
PIP MODE
NOTE: When using Y-P
B
P
R
input, only 480i signal can be viewed as a single mode PIP.