ACCESSORIES
4
1. Remote Control Unit CLU-3841WL (P# HL02061) 6. 55” Table Top Stand (TTS55) (P# QJ01441K) (Optional).
or CLU-3843WL (P# HL02063).
2. Two “AA” size, 1.5V batteries (P# FQ00021). 7. Sub Woofer Cable (P# VZ11701).
3. Power Cord: 8. Cleaning Cloth (P# MS00931).
9. Speaker wires (for monitor speakers).
4. Monitor Connection Cable (P# EW07883).
5. Two IR Mouse cables (P# EY01641).
REMOTE CONTROL BATTERY INSTALLATION AND REPLACEMENT
1. Open the battery cover of the remote control by pushing the notched part of the cover with your fingers and pulling the
cover off.
2. Insert two new “AA” size batteries for the remote control. When replacing
old batteries, push them towards the springs and lift them out.
3. Match the batteries to the (+) and (-) marks in the battery compartment.
4. Replace the cover.
BOTTOM VIEW
(Remote Control)
Press down and slide back
to remove.
CAUTION: Danger of explosion if battery is incorrectly replaced. Replace with the same or equivalent type.
CAUTION: 1. Ceiling mounting is not recommended. Mounting the panel on the ceiling does not provide adequate
ventilation for the electronics or proper support for the front glass panel. This plasma television product is
designed for a maximum tilting angle of 45 degrees from vertical.
2. This TTS55 stand for use only with Hitachi 55HDT51. Use with other apparatus is capable of resulting in
instability causing possible injury. See important marking located on bottom of stand.
REMOTE BATTERIES POWER CORD MONITOR IR MOUSE
CONTROL CONNECTION CABLE CABLE
3. 4. 5.
1.
7.
TTS55 Table Top Stand
(optional)
8.
2.
6.
Subwoofer Cable
Cleaning Cloth
9.
Speaker Wires
Check to make sure you have the following accessories before disposing of the packing material.
FIRST TIME USE
42” 55”
Plasma Monitor EV01841 EV01841
AVC EV01841 EV01841