Hitachi 57F59A Projection Television User Manual


 
65 ” Disassembly/Assembly Instructions
IMPORTANT POINTS:
(a) Do not attempt to perform this work by yourself.
(b) Request an installation specialist to install this unit.
(c) HITACHI assumes no responsibility or liability for injury/damage as a result of consumer installation and
handling. Be advised that improper consumer installation/handling is not covered by manufacturers warranty.
(d) This Projection Television weighs 309 pounds and has many sensitive components.
CAUTION: DISCONNECT UNIT FROM POWER SOURCE BEFORE DISASSEMBLY/ASSEMBLY
DISASSEMBLY PROCEDURE
NOTE: Read all instructions and understand how to properly and safely disassemble and assemble unit
STEP 1
Before disassembling this projection TV set, you
must first remove the speaker grille by grabbing the
sides and pulling left and right side see (a)(b).
STEP 3
(a)
(b)
(a)
(b) (c)
(c)
(d)
(e)
Remove the front decoration panels by unscrewing
the 2 screws from each panel (left & right), see (c),
then remove from the original position, see (d)(e).
STEP 2
Remove the 8
screws that hold
the screen frame to
the cabinet on the
front side. DO NOT
remove the right and
left edge screen
frame screws (c).
Locate the SENSOR PWB attaced to the cabinet
(a). Losen the sensor wires from the plastic holders
in order to remove the 3 wires that comes from
the screen, see (b). Disconnect the 3 connector wires
as it shows on picture (c) & (d).
(a)
(c)
(d)
(b)
65 ” Disassembly/Assembly Instructions
Useful Information
64