Hitachi 57F710G Projection Television User Manual


 
8
Front Panel Controls
First time use
³ MENU/SELECT button
This button allows you to enter the MENU, making
it possible to set TV features to your preference
without using the remote. This button also serves
as the SELECT button when in MENU mode.
· INPUT/EXIT button
Press this button to display the input menu,
CABLE, AIR, INPUT: 1, 2, 3, 4 and 5. This button
also serves as the EXIT button when in MENU
mode.
» CHANNEL selector
Press these buttons until the desired channel
appears in the top right corner of the TV screen.
These buttons also serve as the cursor down (
̄)
and up (
̆) buttons when in MENU mode.
¿ VOLUME level
Press these buttons for your desired sound level.
The volume level will be displayed on the TV
screen. These buttons also serve as the cursor left
(
̇) and right (̈) buttons when in MENU mode.
When the TV power is turned OFF at a volume level
31 or greater, the volume level will default to 30
when the TV is turned ON. However, if it is set to a
level 30 or less, the volume level will be at the level
it was set when the TV is turned ON.
´ POWER button/ POWER LED
Press this button to turn the TV on or off. This LED
light is on during normal operation. At initial TV turn
on, the TV cannot receive any button or Remote
Control signals for approximately five seconds
while the internal programming is loading. This is a
normal default operation of this television and is an
energy saving feature. You can choose not to use
this feature by selecting ON for the QUICK START
UP option in the On Screen Display Menu. Select
SETUP in the On Screen Display Menu, then select
QUICK START UP. Select the ON feature to
quickly tune and view channels at initial TV turn on
(see page 55).
² MAGIC FOCUS
Use this button to automatically adjust your picture
quality to optimum performance (see page 48).
FRONT INPUT JACKS (INPUT 5)
Use these audio/video jacks for a quick hook-up
from a camcorder or VCR to instantly view your
favorite show or new recording. Press the INPUT
button and select INPUT 5. If you have mono
sound, insert the audio cable into the left audio
jack.
º IR RECEIVER Sensor
Point the remote control at this area when selecting
channels, adjusting volume, etc.
POWER
5
S-VIDEO VIDEO
AUDIO
L/MONO R
EXIT
INPUT
SELECT
MENUVOL- VOL+ CH- CH+
̈
̈
̇̆̄
»
²
³
·
¿
´
CURSOR
MAGIC
FOCUS
´
º
INPUT