Hitachi 57T500 Projection Television User Manual


 
25
THE REMOTE CONTROL
HOW TO USE THE REMOTE TO CONTROL YOUR TV
C.C. button
Press this button to quickly turn the Closed Caption feature on, off and auto. You can also access this feature on the Setup menu
(See page 71).
PVR (Personal Video Recorder) button
When pressed, this button will blink to indicate the remote is in PVR mode (see page 41).
CD and AMP buttons
When pressed, each of these buttons will blink to indicate the remote is in Audio mode (see page 42).
CHANNEL selector buttons
CHANNEL selector buttons are used to select channels, lock access code, etc.
Enter one, two, or three numbers to select channels. Enter “0” first for channels 1 to 9, or simply press the single digit channel you
wish to tune then wait a few seconds for the TV to tune. For channels 100 and above, press the “1” button, wait until two dashes
appear next to the channel display on your TV, then enter the remaining two numbers using the number buttons.
Channel selection may also be performed by pressing CH up (̆) or down (̄).
SLEEP and (-) DASH button
Press this button to display the sleep timer in the lower left corner of the screen. Every subsequent press of this button will add 15
minutes to this timer, up to a maximum of three hours. Once set, use INFO when you want to view time remaining. If the SLEEP
button is pressed while the timer is set, it will reset to the original condition. The DASH (-) button can only be used when the remote
control is in Set-Top-Box (STB) mode.
INFO button
Press this button when you want to check the channel being received, the picture source, if the channel has stereo (ST) or second
audio program (SAP), the time, CHANNEL ID and if the SLEEP timer is set.
ANTENNA button
The ANT button will select between Antenna A and Antenna B each time the button is pressed.
NOTE: The TV may not receive some channels if you are not in the correct ANTENNA/CABLE mode (see page 54).
Main Picture Source
Time
Wide
Mode
Day/Night
Mode
Closed
Captioning
Off Timer
Sleep Timer
3:32 PM
Ant A 22
Stereo
R
1080i Format
Day 4:3 Expanded HD 1080i
Off 0:00 AM -:--
View
Zzzz
CC
Audio Broadcast
Broadcast Rating
Signal Format
Virtual HD
When an S-VIDEO
Input is connected to
VIDEO: 3.
When a
COMPONENT
VIDEO: Y-P
B
P
R
Input
is connected to
VIDEO: 1.
3:32 PM
S-IN: 3
VID 3
3:32 PM
YPBPR: 1
VID: 1
3:32 PM
Ant B 22
Stereo
R
3:32 PM
Ant A 15
Stereo
G
ANT