Hitachi 57UWX20B Projection Television User Manual


 
SETUP
55
This function will automatically turn the Projection TV on and off, one time only, every day, or once a
week.
Use CURSOR ̄ to select Event 1, 2 or 3.
Use CURSOR ̈ to change position of On time, Off time, Antenna, Channel, and On/Off Frequency.
Use CURSOR ̆ or ̄ to select the time the TV will turn on and off.
Use CURSOR ̆ or ̄ to select the day of the week you want the timer to turn on TV.
Use number buttons to set the channel the TV will tune to when it automatically turns on.
Use CURSOR ̆ or ̄ to select mode Once (TV will turn on/off one time only), Daily (TV will turn on/off at the same time every day), or
Weekly-SUN (TV will turn on/off at same time every week).
Press EXIT to quit the menu.
NOTE: 1. The Off Timer will only activate if the TV was turned on by the On Timer and no channel selection was
made after this time. If you change the channel after the On Timer has been activated, the Off Timer will deactivate.
2. If no remote control button is pressed after Event Timer is activated, the TV will automatically turn off after three hours.
Therefore, do not Set Event Timer for more than three hours if you do not plan to send a Remote Control I/R to your
TV.
CAUTION: Do not use your TV as a deterrent when away from home by using the On and Off Timers. For safety, the TV
should be turned off when you are away from home.
Set Event Timer
Set The Channels
Set The Clock
Menu Preference
Setup
Set The Inputs
Move
SEL
Select
Set Event Timer
Set Closed Captions
Setup
Move
SEL
Return
Set Event Timer
Event 1 --:-- AM --:-- AM
Ant A Ch -- Once
Event 2 --:-- AM --:-- AM
Ant A Ch -- Once
Event 3 --:-- AM --:-- AM
Ant A Ch -- Once
Setup
Move
SEL
On/Off
Set Event Timer
Event 1 --:-- AM --:-- AM
Ant A Ch -- Once
Event 2 --:-- AM --:-- AM
Ant A Ch -- Once
Event 3 --:-- AM --:-- AM
Ant A Ch -- Once
Return
About Your TV
CURSOR
CURSOR
Please Set Clock First.
If the clock is not set, you can not use this function and the screen below will appear. The message on the screen will disappear after
3 seconds, then the screen automatically goes to the clock setup mode (see page 50).