Hitachi 60V500E Projection Television User Manual


 
23
THE REMOTE CONTROL
In addition to controlling all the functions on your HITACHI LCD Rear PTV, the new remote control is designed to operate differ-
ent types of VCRs, CATV (Cable TV) converters, set-top-box, satellite receiver, DVD players, and other audio equipment with one
touch. Basic operation keys are grouped together in one area. If you prefer to use the AV Network feature, switching remote con-
trol modes is not needed.
To operate your TV, point the remote control at the screen of the TV and press the TV button. The TV button will blink, indicat-
ing that the remote will now control your television.
To operate your VCR, point the remote at the remote sensor of the VCR and press the VCR button. The VCR button will blink,
indicating that the remote will now control your VCR (see page 37 for instructions on how to program the remote to control your
VCR).
To operate your cable box, point the remote at the remote sensor of the cable box and press the CABLE (CBL) button. The CBL
button will blink, indicating that the remote will now control your cable box (see page 38 for instructions on how to program the
remote to control your cable box).
To operate your set-top-box or satellite receiver point the remote at the remote sensor of the set-top-box and press the SET-TOP-
BOX (STB) button. The STB button will blink, indicating that the remote will now control your set-top-box. If you have a satellite
receiver, use this button to program your satellite receiver (see page 39 for instructions on how to program the remote to control
your set-top-box).
To operate your DVD player, point the remote at the remote sensor of the DVD player and press the DVD button. The DVD but-
ton will blink, indicating that the remote will now control your DVD player (see page 40 for instruction on how to program the
remote to control your DVD player).
To operate your PVR (Personal Video Recorder), point the remote at the remote sensor of the PVR and press the PVR button.
The PVR button will blink, indicating that the remote will now control your PVR (see page 41 for instruction on how to program
the remote to control your PVR).
To operate additional audio equipment, point the remote at the remote sensor of the component you wish to control and press
the CD, PVR or AMP button. This button will blink, indicating that the remote will now control the desired component (see page
42 for instructions on how to program the remote to control additional Audio equipment).
These buttons allow the remote to control your TV, VCR,
cable box, satellite receiver, DVD player, or other
Audio equipment depending on which mode is
chosen, as explained above.
,LIGHT BUTTON
When you are in a dark room, press the light button
on the remote to light up the buttons shown in and the
source button will blink. Thelight will stay on for about 8
seconds if any of the buttons are not pressed again.
These buttons will not appear to light if the room is too
bright.
POWER
TV
VCR
CBL
DVD
1
2
4
56
3
7
89
0
INFOSLEEP
A/V NET
E
X
I
T
M
E
N
U
CHVOL
M
U
T
E
PIP SURF
SWAP
FREEZE
PIP MODE
PIP ACCESS
DAY/NIGHT
SOURCE WIZARD
REC
SELECT
C
.C
.
A
S
P
E
C
T
STB
A
N
T
LAST CH
VID1
V
ID
2
VID3
V
ID
4
VID5
PVR
CD
AMP
V
ID
E
O
CLU-5729TSI
THE REMOTE CONTROL
QR57028 8/17/05 2:49 PM Page 23