Hitachi L40A105 Flat Panel Television User Manual


 
14
DISPLAY
Press DISPLAY to display the current information on the screen.
When the TV receives a digital signal, the digital information will
appear.
62-1 HDMI_Moving_Picture...
CH-1 TV-MA
Digital Air
No Program Information is available
Sleep Timer
Off
English
Full
1080i
Channel number Station name
Channel label (if preset)
Broadcast program name
Parental Control Signal type
Sleep timer Audio language
Program guide Picture size
Resolution
When the TV receives an analog signal, the analog information will
appear.
X
14
Analog Cable
Sleep Timer
Off
Mono
Full
480i
Channel number Channel label (if preset)
Parental Control Signal type
Sleep timer Picture size
Audio information
(Stereo, SAP or Mono)
Resolution
Press DISPLAY again to clear the display.
NOTE:
After a few seconds the DISPLAY screen will return to normal
TV-operation automatically.
LAST CH
This button allows you to go back to the last channel selected by
pressing LAST CH. Press LAST CH again to return to the last
channel you were watching.
MUTE
Press MUTE to switch off the sound. The TV’s sound will be
silenced and “Mute” will appear on the screen. The sound can be
switched back on by pressing this button again or by pressing the
VOL + orbuttons.
SLEEP
To set the TV to turn off after a preset amount of time, press
SLEEP on the remote control. The clock will count up 10 minutes
for each press of the SLEEP button (Off, 0h 10m, 0h 20m, ..., 2h
0m). After the sleep timer is programmed, the display will appear
briefly every ten minutes to remind you that the sleep timer is
operating. To confirm the sleep timer setting, press SLEEP and
the remaining time will be displayed for a few seconds. To cancel
the sleep timer, press SLEEP repeatedly until the display turns to
Off.
Quick guide for menu
operation
Example: Select Menu Language.
1
Press INPUT to select TV mode.
2
Press MENU. The TV menu screen will appear.
Audio
Channel
Locks
Setup
Main Menu
Video
>>
ENTER :Select:Move
CH
3
Press or to select “Setup”, then press or ENTER.
4
Press or to select “Menu Language”, then press or
to select the desired language.
On the following pages the menu can be called in the same
way as here.
5
Press EXIT to return to the normal screen.
NOTE:
If no buttons are pressed for more than 60 seconds, the menu
screen will clear and the TV will return to normal viewing
automatically.
3FV1021A_eng.indd 143FV1021A_eng.indd 14 3/14/11 10:22:02 AM3/14/11 10:22:02 AM