Filter
Top Products
USING THE REMOTE TO CONTROL VCR FUNCTIONS - 23 -
Operating the pre-coded function for your VCR
This remote is designed to operate different types of VCRs. You must first program the
remote to match the remote system in your VCR. (Refer to page 22).
1. Turn ON your VCR.
2. Aim the remote control at the front of your VCR.
3. Press the VCR button to switch to the VCR pre-coded mode.
4. While holding down the SELECT button, enter the 2 digit preset code that matches
your VCR as shown on page 22. The remote will turn off your VCR when the correct 2
digit preset code is entered. When this occurs, the remote control is programmed for
your VCR. If the VCR does not turn off after 5 seconds, try a different 2 digit preset
code.
5. The remote will now control your VCR.
NOTES:
1. If your VCR cannot be operated after performing the above procedures, this means that
your VCR's codes have not been precoded into the remote.
2. In the unlikely event that your VCR cannot be operated after performing the above
procedures, please consult your VCR operating guide.
3. The remote control will remember the codes you have programmed in until the batteries
are removed from the remote control. After replacing the batteries repeat the entire
programming procedure stated above.
4. If your VCR does not have a power function, the remote will issue the CHANNEL UP
function.
Remote Control Buttons
VCR BUTTON
This button allows the remote to control your VCR by setting it to VCR mode.
SELECT BUTTON
This is for setting up the remote to transmit the VCR's remote codes.
PRECODED VCR BUTTONS
These buttons transmit the chosen precoded VCR codes. For some VCR's, you must
press the RECORD button twice to record a program.
EXCLUSIVE TV BUTTONS
These buttons are for operating the TV.