Filter
Top Products
– The SRU 5040 now starts emitting all known
‘TV off ’ signals,one by one.
Each time a code is sent,TV in the selector
window lights up.
5 When your TV switches off (stand-by), release the Standby key of the
SRU 5040 immediately.
– The SRU 5040 has now found a code that works on your TV.
6 Check if you can operate all functions on your TV with the SRU 5040.
• If this is not the case, you can redo the automatic setting.
The SRU 5040 will then search for a code that works better.
– After the SRU 5040 has run through all the known codes, the search
will stop automatically and TV in the selector window will stop flashing.
– Automatic programming of a TV takes a maximum of 5 minutes.
For DVD,VCR and STB this time is 2 minutes
Manually setting the remote control
Example of TV:
1 Turn on the TV manually or use the original remote control.
Tune in to channel 1.
2 Look up the brand of your TV in the
code list at the back of this manual. One or
more four-figure codes are shown for each
brand. Note the first code.
Be careful! There are separate tables for TV, video,
DVD,etc.
On our website www.philips.com/urc you can directly select your device
typenumber to find the right code.
Make sure you use the codes from the correct table.
3 Press the SELECT key to select TV.
Press the key until TV lights up in the selector
window.
4 Keep keys1 and 3 pressed simultaneously
for five seconds until TV in the selector
window flashes twice and then remains lit.
5 Then enter the code noted in step 2 using the digit keys.
– TV in the selector window will now flash twice.
If TV flashes once for an extended period, the code has not been
entered properly or the wrong code has been entered.
Start again from step 2.
6 Point the SRU 5040 at the TV and check that it responds as it should.
– If the TV responds to all of the key commands,the SRU 5040 is ready
for use. Do not forget to note your code.
6
Instructions for use
English