Filter
Top Products
24
ENGLISH
BASIC OPERATION
Power On/Off
Turn On the power of the unit.
To turn On the power to the unit:
1. Press the Main Power switch on the unit.
The Indicating Lamp illuminates in Green on
Monitor/Blue on A/V Center, and the Illumination
Lamp turns Blue.
The image will display on screen.
2. Once the Main Power switch is on, you can turn On/Off by
pressing the Power (On/Off) button on the remote control.
To turn Off the power to the unit:
1. Press the Power (On/Off) button on the remote control.
The image disappears from the screen. The Indicating
Lamp turns Red (Standby mode) on Monitor and A/V
Center, and the Illumination Lamp turns off.
2. Press the Main Power switch on the Monitor to completely
turn Off the power to the Monitor.
NOTE
While the Indicating Lamp illuminates in Red (Standby mode),
you can turn On/Off by pressing the Power (On/Off) button on
the remote control.
The Indicating Lamp/Illumination Lamp Status of the Monitor
Indicating
Lamp
Illumination
Lamp
Power Status Remark
Off – Off –
Red – Standby mode –
Green Blue On –
Orange – Power Save mode
Refer to
44
for the condition.
Blinking Green Blue On Receiving Remote Control signal
The Indicating Lamp Status of A/V Center
Indicating
Lamp
Power Status
Off Off
Red Standby mode
Blue On
NOTE
If the image does not appear on the screen at all, or if there is any problem with it, see “TROUBLESHOOTING” on
45
~
47
. This may help you to solve the problems.
After turning On, it takes about 6 seconds until the monitor starts up. Please note that buttons on the remote control
and the unit (such as the Power button) do not work during this period of time.
If power is interrupted during use of the unit, to avoid sudden surges of electricity when the power comes back on,
turn off the main power to the unit before leaving home.
Main Power Switch
(on the underside)
Front
Rear
Power On/Off button
Illumination Lamp
Indicating Lamp