Filter
Top Products
26
REGULATORY REQUIREMENTS AND WARNINGS
United States
Laser Safety
To assist with the FDA filing requirements (refer to Regulatory Requirements on
page 24), Metrologic has registered the scan engine with the FDA as a
component. Customers can contact CDRH at the following address:
Food and Drug Administration
Center for Devices and Radiological Health
Light Products Branch (HFX-312)
Office of Compliance
2098 Gaither Road
Rockville, MD 20850
Tel: 301-594-4654
www.fda.gov/cdrh
Requ
irements for laser products are described in CFR (Code of Federal
Regulation) Title 21, part 1040.10 & 1040.11 from the Government Printing Office.
Copies can be ordered by calling 202-512-1800, ordering on line from
www.access.gpo.gov/su_docs or writing to:
Superinte
ndent of Documents
PO Box 371954
Pittsburgh, PA 15250-7954
Note: State and local governments may regulate the use products containing
lasers. The manufacturer should consult the applicable government
regulations for more information.
EMC
The IS4125 has been tested to meet Class B EMC Standards. The integrator is
responsible to maintain proper EMC techniques to maintain this performance
level.
Certain combinations of scan engines and associated electronics may require
testing to insure compliance with the following Federal Communications
Commission regulation: 47 CFR Part 15
Note: When using the scan engine with RF equipment, modems, etc. may
require examination(s) to the standard(s) for the specific equipment
combination. It is the manufacturers’ responsibility to comply with the
applicable federal regulation(s).