Filter
Top Products
Reference
GB7
All our receivers are designed to be DiSEqC 1.0 compatible. This allows multiple antennas to be
connected to the STB simultaneously.
If you have two or more fixed antennas or LNBs, you can use a DiSEqC 1.0 switch.
1. Connect the coaxial cable from the first LNB to the LNB 1 or LNB A input connector of the
DiSEqC switch.
2. Connect the coaxial cable from the second LNB to the LNB 2 or LNB B input connector of the
DiSEqC switch.
3. Do the same for other LNBs.
4. Connect one end of a Coaxial cable to the RF output connector of the DiSEqC switch and the
other end to the LNB IN socket on the STB.
Please refer to page GB37.
The Locking Time might take longer than expected during the initial boot if the motorised system
is set “enable” mode.
To the digital receiver, you can connect either a single satellite antenna directly or through
converter box several antennas or LNB of multi-feed equipment.
You can connect a further Sat-receiver (for example analog), with the receiver of common
antenna equipment that has satellite signals.
1. Connect DiSEqC 1.0
2. Connect DiSEqC 1.2
3. Connect a Satellite antenna