Filter
Top Products
Quick Disconnect Mounting Bracket
1
530516-1_D
Thank You
Thank you for choosing Humminbird®, America's #1 name in fishfinders. Humminbird® has built its reputation
by designing and manufacturing top-quality, thoroughly reliable marine equipment. Genuine Humminbird®
accessories offer the opportunity to upgrade and expand the capabilities of your Humminbird® product.
Your Humminbird® accessory is designed for trouble-free use in even the harshest marine environment.
In the unlikely event that your Humminbird® accessory does require repairs, we offer an exclusive Service
Policy - free of charge during the first year after purchase, and available at a reasonable rate after the
one-year period. For complete details, see the Warranty section included in this manual.
Contact our Customer Resource Center at 1-800-633-1468 or visit our website at www.humminbird.com.
Installation Overview
Following are instructions for the installation of this accessory. Before you start installation, we encourage
you to read these instructions carefully in order to get the full benefit from your Humminbird® accessory.
If you find that any items are missing from your installation kit, call our Customer Resource Center at
1-800-633-1468 or visit our website at www.humminbird.com.
To install your Quick Disconnect mounting system, you will need a drill, your control head, the mounting
bracket, the connector holder, the power cable, the mounting hardware, a 9/64" drill bit, a 1" hole saw, a
Phillips and a flat-head screw driver, an adjustable wrench, a level, and marine-grade silicone sealant.
Installation
Perform the procedures in the following sections to install the Wide Quick Disconnect mounting system on
your boat.
1. Determine Where to Mount
Begin the installation by determining where to mount the control head. Consider the following to determine
the best location:
• To check the location planned for the control head, test run the cables for power, transducer and
Temp/Speed accessory (if applicable).
• There are two ways to route the cables to the unit: through a hole in the mounting surface underneath
the mounting bracket, or from a hole outside the mounting bracket. Routing the cables under the
mounting bracket provides maximum weather protection; this may not be feasible, however, if the area
under the control head is inaccessible. In this case, route the cables through a hole at another location
and cover with the supplied hole cover.
• The mounting surface should be stable enough to protect the control head from excessive wave shock
and vibration, and should provide visibility while in operation.
• The mounting area should allow sufficient room for the unit to pivot and swivel freely, and for easy
removal and installation (see illustrations).
© 2008 Humminbird®, Eufaula AL, USA.
All rights reserved.
360 Degree Swivel
90 Degree Tilt