Filter
Top Products
Quick Disconnect Mounting Bracket
3
530516-1_D
4. Connecting the Cable
1. Insert the cable connector into the appropriate slots of the connector holder. The cable connectors are
labeled, and there are corresponding labels on the connector holder on the rear of the fishfinder. The
slots are keyed to prevent reversed installation, so be careful not to force the connector into the holder.
2. Carefully pull the excess cable from beneath the mounting surface so the connector holder aligns with
the mounting holes on the front of the mounting bracket.
3. Snap the support plate to the rear of the connector holder as illustrated.
4. Insert the connector holder into place and use the two #6-32 x 3/4” screws to fasten it to the mounting
bracket.
5. Install the control head by sliding it onto the mounting bracket until it is fully seated. To remove the unit,
simply depress the latch on the rear of the unit and lift.
6. If the cables pass outside the mounting bracket, reinstall the hole cover over the thru-hole and fasten
in place using the two #8 x 7/8” wood screws.
Your fishfinder is now ready for operation.
Snap the Support Plate onto
the Connector Holder
Attach the Connector Holder
to the Mounting Bracket
Support
Plate
© 2008 Humminbird®, Eufaula AL, USA.
All rights reserved.
Transducer Accessory
Communications Power
Cable Connector Holder
Connector Holder
Cable Connector
Firmly Press
Latch to
Remove Unit