Filter
Top Products
39
Clock Set
See
page 20.
OSD On/Off
To activate or deactivate the operational status display on the TV screen.
On
Activates the operational status display (e.g., ) on the TV screen.
Off
Deactivates the operational status display (e.g., ) on the TV screen.
Remote Controller Sound
To turn on or off the confirmation beeper announcing when each remote command is received.
On Turns on the beep sound.
Off Turns off the beep sound.
Screen Saver
Auto Power Off Turns the player off if stop mode or picture pausing continues for about 20 minutes.
On Activates the screen saver if stop mode or picture pausing continues for about 20 minutes.
Off Deactivates the screen saver.
Notes
• Onkyo does not guarantee that this function will protect your display.
• To close the screen saver, press any button on the player or the remote control.
• When an HD DVD disc is used, this function activates only in stop mode.
Maintenance
Initialize
To reset all the settings listed on
page 33, 34 to factory set default.
Press / buttons to select “Yes” then press OK button.
Update (Firmware
update)
If you have a broadband internet service, you may obtain firmware update over the internet using the
ETHERNET port on the back of your player.
• BEFORE BEGINNING THE FIRMWARE UPDATE PROCESS, BE SURE TO REMOVE ANY DISCS
FROM YOUR PLAYER.
Please configure the ETHERNET port (
page 17). You may need to turn on DHCP and DNS ( page
25).
• Press Setup and select “General” > “Maintenance”. Follow the instructions on the screen.
• If a firmware update is available for your player, the player will download it. Once the firmware update
download process has finished, the player’s power will automatically switch off. You must wait until this
process has finished.
•
DO NOT UNPLUG, TURN OFF, OR USE ANY OTHER FEATURE OF YOUR PLAYER DURING THE
FIRMWARE UPDATE PROCESS. Doing so will cause the writing of the firmware update to the player to
be halted and the player may no longer operate properly. If the player stops working, please contact the
dealer from whom you purchased this unit.
• If no firmware update is available, the player will quickly exit the firmware update process.
Persistent Storage To open the menu to control player’s memory allocated for content. (Not available while a disc is loaded.)
The menu selections will vary depending on the content. Operate following the instructions displayed on
your screen.
Twin Format Disc
To select a layer to play, HD DVD or DVD of an HD DVD Twin Format Disc. (Not available if a disc is loaded.)
HD DVD Only the HD DVD layer is played.
DVD Only the DVD layer is played.
Note
• For combination discs, select the desired version by disc side (see label for information).
DHS-8.8_En.indb 39 2007/10/09 18:16:54