Jasco RM84911 Universal Remote User Manual


 
7
Code Search
If your device does not respond after you have
tried all the codes for your brand, or if your brand is
not listed, try searching for your code by following
these steps.
1. Manually turn on the device (
TV
,
VCR
, etc.) to
be controlled.
2. Press and hold the
SETUP
button
until the red indicator stays on, then
release the
SETUP
button.
3. Press and quickly release the desired
device button (
TV
,
VCR
, etc.). The
red indicator blinks off once.
4. Press the
ON•OFF
button
repeatedly (up to 300 times) until
the device to be controlled turns
off. The red indicator blinks off with
each button press.
Most users will store VCR codes under the
VCR
button, Cable codes under
CABLE
, etc. If (for
example) you want to store a VCR code under
CABLE
, fi rst follow the procedure for Direct Code
Entry (previous page) and press
CABLE
in step 2
of Direct Code Entry, then enter ANY VCR code in
step 3 of Direct Code Entry. Then follow the steps
above for Code Search.
Note
: Code Search starts from the currently
stored three digit number under that mode.
Sometimes the fi rst code that “works” with your
device may only allow limited functionality (e.g.
the MENU button might not work). There may be
a code that performs more functions. Continue the
code search process until the best code is found.
5. Press and release
ENTER
to install the
code.