Jensen JE1908 Flat Panel Television User Manual


 
15
Turn down the volume before connecting headphones to the unit, then adjust the volume to
your desired level.
When headphones are connected, no sound will come from the front speakers.
Note:
Avoid listening to sound at high levels for prolonged periods of time. This may be harmful to
you and may cause hearing loss.
USING HEADPHONES
UNIT OPERATION
TURNING THE UNIT ON FOR THE FIRST TIME
The first time for you turning on the unit, the unit will enter Virgin mode. You can easily follow
up prompt message on screen to finish basic settings of the system.
1. Press the ENTER button to proceed the Initial Setup.
2. Use the
/ button to select your OSD language, and press the
button to the next step.
3. Use the
/ button to select your TV tuner source (Antenna or Cable), and press the
button to the next step.
4. Make sure RF aerial has been connected properly to TV ANTENNA input jack on the rear of
the system, press the ENTER or button. The system will automatically start to scan and
preset all available TV channels.
5. After scaning finished, “Inital setup is Complete.” will appear on the screen. Press the
ENTER button to finish Initial Setup.
After finishing above settings, the system will return to the first TV channel scaned just now.
Note: When the unit is not going to be used for a long time, disconnect the AC power adapter
from AC power outlet.
PLV36190CS1_IB_ENG_JEN_R1.pmd 11/2/2007, 5:23 PM15