JVC 0701MNV*ID*PJ VCR User Manual


 
26 EN
TIMER RECORDING
Turn on the TV and select the VIDEO channel (or AV mode).
Guide Program Number Set
ACCESS MAIN MENU
SCREEN
1
Press MENU.
ACCESS INITIAL SET
SCREEN
2
Press PUSH JOG %fi to place the pointer next to
"INITIAL SET", then press OK or PUSH JOG
#
.
ACCESS G-CODE/
SHOWVIEW SETUP
SCREEN
3
Press PUSH JOG %fi to place the pointer next to
"G-CODE/SHOWVIEW SETUP", then press OK or
PUSH JOG
#
.
ENTER GUIDE PROG
NUMBER
4
Press PUSH JOG %fi or
NUMBER keys to enter the
Guide Program number for
the desired station as shown
in the TV listings. Then press
OK or PUSH JOG
#
.
The G-CODE timer programming system eliminates the need to
input channel, date, start and stop time data when setting the
timer record function. Simply key in the G-CODE number for the
TV programme you wish to record (found in most TV listings)
and the recorder's timer is automatically programmed.
You have to set "GUIDE PROG" numbers, which are assigned to
each station for purposes of G-CODE timer programming, for all the
stations stored in your recorder's memory to get proper results.
Before G-CODE system setup you must have performed the
following procedures:
Tuner setting ( pg. 8, 54)
Clock setting ( pg. 12)
IMPORTANT
Perform the following procedure after Auto Set Up on page 8
and/or the channel setting steps on pages 54– 57.
After setting the Guide Program Numbers, channel positions
may be incorrect if you stored or skipped channels. In this case,
re-perform Guide Program Number setting.
NUMBER
PUSH JOG
MENU
OK
G-CODE/SHOWVIEW SETUP
GUIDE PROG TV PROG
25
[0-9] OR [
5
/
]:SELECT =
[MENU] : EXIT
G-
CODE
/S
HOW
V
IEW
System Setup
INFORMATION
G-CODE and SHOWVIEW are different trademarks used to
represent the same easy recording feature, but only the term
G-CODE system will be used in the instructions. If you use the
SHOWVIEW system, follow the same instructions listed for
the G-CODE system.