JVC 0705JGI-II-IM Projection Television User Manual


 
20
Quick Setup Connections
By connecting a Digital TV Reciever, high definition pictures can be displayed on your TV in
their digital form.
TV Rear Panel
DTV Decoder
HDMI to DVI Cable
After the connections have been made,
tighten the screw to secure the cables.
VIDEO
(DIGITAL)
AUDIO
(DIGITAL)
DIGITAL-IN
LR
AUDIO OUTDIGITAL OUT
OVER
75Ω
(VHF/UHF)
AUDIO
OUT
R
L
OPTICAL OUT
Digital
Audio
AUDIO
R L
VIDEO S-VIDEO
OVER
INPUT-3
INPUT-2
INPUT-1
COMPONENT VIDEO
Y Pb Pr
Connecting to a Digital TV Receiver
1) Connect the HDMI to DVI Cable from the DIGITAL OUT on the back of your DTV decoder, to
the DIGITAL-IN on the back of your television.
2) Connect a red cable from the DTV decoder RIGHT AUDIO OUT, to the RIGHT AUDIO IN into
VIDEO-3 on the back of your television.
3) Connect a white cable from the DTV decoder LEFT AUDIO OUT, to the LEFT AUDIO IN into
VIDEO-3 on the back of your television.
• The digital-in terminal is not compatible with the picture signal of a personal computer.
• Use a HDMI to DVI cable (commercially available) in order to digitally connect the television
with a DTV decoder.
Notes:
• If 480p signals (640x480 or 720x480) are displayed on the screen, the horizontal balance
may be slightly shifted. Access the “DIGITAL-IN” in the initial setup menu to adjust it. (Refer
to page 52.)
• When you do the above connection, set DIGITAL-IN AUDIO in the Initial Setup menu to
ANALOG. See "DIGITAL-IN AUDIO", page 52.
LCT1885-001A-A ENG 20 7/20/05, 9:07:46 AM