Filter
Top Products
10
Quick Setup Getting Started
These quick setup pages will provide you, in three easy steps, with the basic information you
need to begin using your new television right away.
If you have questions, or for more detailed information on any of these steps, please consult
other sections of this manual.
Before you can operate your remote control, you first need to install the batteries (included).
With your thumb, push the latch on the back
of the remote control inward, and while
holding it there, pull the battery cover out
with your index finger. Insert the battery
(included) carefully noting the “+” and “–”
markings. Push the cover back into place.
Getting Started
Step 1 – The Remote Control
Key Feature Buttons
The four key feature buttons at the center of the remote
can be used for basic operation of the television. The
top and bottom buttons will scan forward and back
through the available channels. To move rapidly through
the channels using JVC’s Hyperscan feature, press
and hold CH+ or CH –. The channels will zip by at a
rate of five channels per second. The right and left
buttons will turn the volume up or down. These buttons
are also marked with four arrows and are used with
JVC’s onscreen menu system. To use the onscreen
menus, press the M
ENU button.
MUTING
C.C.
MENU
EXIT
CH
VOL
VOL
CH
Note: Illustration of remote
control RM-C203G
MADEIN
C
H
I
NA
LITHIUMBA
T
TERY
INSIDE
SEE
MANUAL
1
2
C
R
20
2
5
AV-27\32S\C\WF35 English 10 4/16/04, 1:46:57 PM