Filter
Top Products
No. 52026
A
V-14F3/AV-1435
A
V-1435EE/AV-1435TEE
A
V-14FMT3/AV-1438
A
V-14FMG3/AV-14FMG3B
28
Item
Measuring
instrument
Test point Adjustment part Description
●
●●
● When the vertical linearity has been deteriorated
remarkably, perform the following steps.
15. Input a cross-hatch signal.
16. Select 4. VER. LIN. with the MENU
▼
/
▲
key.
17. Set the initial setting value of 4. VER LIN. with the MENU - / +
key.
18. Select 5. VER. SCURVE with the MENU
▼
/
▲
key.
19. Set the initial setting value of 5. VER. SCURVE with the ME NU
- / + key.
20. Adjust 4. VER. LIN. and 5. VER. SCURVE so that the spaces
of each line as shown in Fig.3 on TOP, CENTER and
BOTTOM become uniform.
Ad just ment
of VER. LIN.
& VER.
SCURVE
Signal
generator
Remote
control unit
4. VER. LIN.
5. VER. SCURVE
Make sure that the adjustment is properly done on the screen of
60Hz mode.
[NOTE]
"
Adjust to make both 50Hz & 60Hz are the same v. size and
fine straight line.
"
When adjust again, adjust 50Hz mode first.
"
When adjust in 60Hz mode, only 60Hz mode is adjust.
VSM PRESET SETTING
Item
Measuring
instrument
Test point Adjustment part Description
Setting of
VSM
PRESET
Remote
control unit
TINT
COLOUR
BRIG HT
CONT.
SHARP
1. Enter the SERVICE MENU.
2. Select 4. VSM PRESET from the SERVICE MENU.
3. Select BRIGHT with the PICTURE MODE key.
4. Adjust the MENU
▼
/
▲
and MENU - / + key to bring the set
values of TINT
～
～～
～
SHARP to the values shown in the below
table.
5. Respectively select the VSM PRESET mode for SOFT and
STANDARD, and make similar adjustment as in 3 above.
TOP
CENTER
BOTTOM
Fig.3
BRI GHT
TINT
COLOUR
BRI GHT
CONT.
SHARP
- / + : OPERATE DISP : EXIT
**
**
**
**
**
/ :SELECT
•
••
• VSM PRESET
VSM
Setting Item
BRIGHT STANDARD SOFT
TINT +15
←
←
COLOUR +15
←←
BRIGHT +15
←←
CONT +30 +15 +11
SHARP +15
←
+12