Filter
Top Products
– 21 –
English
4
ONLY FOR “PRO LOGIC”
Press DELAY TIME repeatedly to
select the proper delay time of the
rear speaker output.
• Each time you press the button, the delay
time changes as follows.
DELAY1: Select this when the distance from you
to your rear speakers is greater than that
to the front speakers.
DELAY2: Select this when the distance from you
to your rear speakers is almost equal to
that to the front speakers.
DELAY3: Select this when the distance from you
to your rear speakers is less than that to
the front speakers.
DELAY4: Select this when the distance from you
to your rear speakers is much less than
that to the front speakers.
5
Press TEST TONE to check the
speaker output balance.
A test tone comes out of the speakers in the
following order:
* “CENTER” does not appear when selecting “PHANTOM” or
“OFF” for the center mode, and no test tone comes out of the
center speakers.
6
Press VOLUME + / – to adjust
the test tone volume to a proper
level.
7
If necessary, adjust the speaker output
balance so that the output level from center
and rear speakers is almost equal to that
from the front speakers:
To adjust the center speaker output level
(from –10 to +10), press CENTER LEVEL
– / +.
• You cannot adjust the center speaker
output level when you select
“PHANTOM” or “OFF” for the center mode.
To adjust the rear speaker output level
(from –10 to +10), press REAR LEVEL – / +.
• You cannot adjust the right and left speaker
output levels separately.
• You cannot adjust the rear speaker output
level when using Dolby 3 Stereo.
*
DELAY TIME
LEFT
(Left front speaker)
SURROUND
(Rear speakers)
CENTER
(Center speaker)
RIGHT
(Right front speaker)
+
–
CENTER
LEVEL
+–
REAR
LEVEL
+–
TEST TONE
TEST TONE
8
Press TEST TONE again to stop the
test tone.
9
Release SHIFT.
Enjoying Playback with Dolby Surround
You can use the settings you have already stored in memory.
On the unit:
1
Press PRO LOGIC / 3 STEREO to
select the Dolby Surround mode you
want.
The PRO LOGIC or 3 STEREO indicator lights
up on the display
• Each time you press the button, the Dolby Surround
modes changes as follows:
• When Dolby Surround is activated, the sound mode is
canceled temporarily.
2
Select and play a sound source encoded with
Dolby Surround (with the
DOLBY SURROUND
mark).
To cancel the Dolby Surround mode, press PRO LOGIC / 3
STEREO repeatedly until neither PRO LOGIC nor 3
STEREO indicator remains lit on the display.
On the remote control:
1
Press and hold SHIFT until the
following procedure is finished.
2
Press PRO LOGIC or 3
STEREO whichever you
want to use.
The PRO LOGIC or 3 STEREO
indicator lights up on the display.
• When Dolby Surround is activated, the sound mode is
canceled temporarily.
3
Select and play a sound source encoded with
Dolby Surround (with the
DOLBY SURROUND
mark).
To cancel the Dolby Surround mode, press PRO LOGIC or
3 STEREO (the same button you have pressed to activate
Dolby Surround in step 1 above) so that neither PRO LOGIC
nor 3 STEREO indicator remains lit on the display.
PRO LOGIC
3 STEREO
Canceled
PRO LOGIC
/ 3 STEREO
SHIFT
PRO LOGIC
3 STEREO
DELAY1 DELAY2
DELAY4 DELAY3
EN20-24.MXJ75R[EV]/3 99.4.19, 9:52 PM21