Filter
Top Products
32
Lamp replacement
EXIT
Warning
Lamp replacement
EXIT
EXIT
1000h
No Signal DVI-D
Cause (Details)
No device is connected to the DVI terminal.
The terminal is connected but there is no signal output.
[ Input the video signals.
When lamp time reaches 1000 hours
[ A message indicating “1000 h” will be displayed on the
screen.
● Press the [EXIT] button to clear the display.
At the moment when the accumulated lamp time reaches
1900 hours, a “Lamp replacement” message will be displayed.
In addition, when the accumulated lamp time reaches
between 1900 hours to 2000 hours, the “Lamp replacement”
message will be displayed each time the projector is turned
on.
● The message can be cleared by pressing the [EXIT]
button or displaying the menu.
[ Get ready a new lamp (lamp unit) in advance or replace
as soon as possible.
The “Warning” word appears and blinks when the
accumulated lamp time exceeds 2000 hours.
The message can be cleared by pressing the [EXIT] button.
However, the same message will reappear every hour.
When the accumulated lamp time exceeds 2000 hours, the
unit cannot be turned on again once it is turned off.
If continuous projection is performed after 2000 hours, the
unit will shut down upon exceeding 2010 hours and projection
will be disabled.
[ Install a new lamp (lamp unit) and reset the lamp time.
(☞ Pages 28 - 30)
What to do when these messages are displayed
Message