JVC HR-674 VCR User Manual


 
Filename [HRJ670EU2.fm]
Masterpage:Left
32
EN
EDITING (cont.)
Edit To Or From
Another Video
Recorder
You can use your recorder as the source player or as the
recording deck.
A
Make connections.
Connect the player’s 21-pin SCART connector to the
recorder’s 21-pin SCART connector as illustrated.
A When using your recorder as the source player ...
... connect its AV1 (L-1) IN/OUT connector to the recording
deck.
B When using your recorder as the recording deck ...
... connect its AV1 (L-1) IN/OUT or AV2 (L-2) IN/DECODER
connector to the source player.
B
Set the input mode of recording deck.
With this video recorder, press
AUX
(
NUMBER
key “
0
”)
and/or
PR
to select “L-1” for the AV1 (L-1) IN/OUT
connector, or “L-2” for the AV2 (L-2) IN/DECODER
connector, depending on the connector being used.
When using another recorder as the recording deck, refer to its
instruction manual.
When using the AV2 (L-2) IN/DECODER connector, make sure
“L-2 SELECT” is set to “L-2” (
pg. 39).
C
Set the edit mode.
See “PICTURE CONTROL” on page 37.
D
Start the source player.
Engage the Play mode of the source player.
E
Start the recording deck.
Engage the Record mode of the recording deck.
NOTES:
All necessary cables can be obtained from your dealer.
When you select “EDIT” to dub tapes in step
3
, be sure to
select “AUTO” (or “NORM” when “B.E.S.T.” is set to “OFF”)
after you finish dubbing the tapes.
When you use this recorder as the source player for editing, be
sure to set “O.S.D.” to “OFF” before starting (
pg. 37).
Video
channel or
AV mode
21-pin SCART cable
(not provided)
Recorder Your recorder
Another recorder
Player
TV receiver
RF cable
(provided)
A
B
Video
channel or
AV mode
21-pin SCART cable
(not provided)
Recorder
Your recorder
Another recorder
Player
TV receiver
RF cable
(provided)
HRJ670EU2.fm Page 32 Thursday, December 9, 1999 3:50 PM