Filter
Top Products
Filename [HRJ670EU3.fm]
Masterpage:Right
EN
37
* The default setting is
bold
in the table below.
8
B.E.S.T.
ON
OFF
You can set the B.E.S.T. (Biconditional Equalised Signal
Tracking) system to “ON” or “OFF” (
੬
pg. 23).
8
PICTURE CONTROL
AUTO
: Provides the optimised picture
benefits of the B.E.S.T. Picture
System.
EDIT
: Minimizes picture degradation
during editing (recording and
playback).
SOFT
: Reduces image coarseness when
viewing overplayed tapes containing
a lot of noise.
SHARP
: Clearer, sharper-edged picture when
viewing images with lots of flat,
same-coloured surfaces such as
cartoons.
This feature helps you to adjust the playback picture
quality according to your preference. Normally select
“AUTO”.
NOTES:
●
When you select “EDIT”, “SOFT” or “SHARP”, the selected
mode will not change until you select another mode.
●
When you select “EDIT” to dub tapes, be sure to select “AUTO”
after you finish dubbing the tapes.
●
When “B.E.S.T.” is “OFF”, “PICTURE CONTROL” switches
automatically from “AUTO” to “NORM”.
8
AUTO TIMER
ON
OFF
When this function is set to “ON”, the timer is
automatically engaged when the recorder power is turned
off, and automatically disengaged when the recorder is
powered back on.
NOTE:
For safety, when “AUTO TIMER” is set to “OFF”, all other recorder
functions are disabled while the Timer mode is engaged. To
disengage the timer, press
# (TIMER).
8
O.S.D.
ON
OFF
When this function is set to “ON”, various operational
indicators appear on the TV screen. Messages appear in
the selected language (
੬
pg. 11 or 12).
NOTES:
●
When you use this recorder as the source player for editing, be
sure to set “O.S.D.” to “OFF” before starting.
●
During playback, the operation mode indicators may be
disturbed depending on the type of tape being used.
8
DIRECT REC
ON
OFF
When this function is set to “ON”, you can easily start
recording the programme that you are watching on your
TV. Press and hold
7
and press
4
on the remote control,
or press
7
on the recorder.
NOTES:
●
When you use the Direct Rec function, be sure to use a TV
offering T-V LINK, etc. and connect a fully-wired 21-pin SCART
cable between the recorder and the TV (
੬
pg. 7).
●
If “DIRECT REC” is set to “OFF”, the
7 button functions as
described in “Basic Recording” (
੬
pg. 20).
●
During the Direct Rec, “– –” appears on the front display panel.
HRJ670EU3.fm Page 37 Thursday, December 9, 1999 3:51 PM