Filter
Top Products
5
The AV2 IN (/DECODER) or AV1 IN/OUT connector can be
used as an input terminal for a satellite tuner. Simply connect a
satellite tuner and you can enjoy the wide variety of satellite
programming.
Connecting/
Using A
Satellite Tuner
SELECT INPUT MODE
(A233E, A433E only)
1
Set the AV2 SELECT switch to “AV2”.
CONNECT SATELLITE
TUNER
2
●
If you own the A230E, A430E or A437E . . .
. . . connect an optional 21-pin SCART cable between
the satellite tuner's Euroconnector and your
recorder's AV1 IN/OUT connector.
●
If you own the A233E , A237E or A433E . . .
. . . connect an optional 21-pin SCART cable between
the satellite tuner's Euroconnector and your
recorder's AV2 IN (/DECODER) connector.
PREPARE TO WATCH A
SATELLITE PROGRAMME
3
Select the appropriate channel on the satellite tuner.
Then set the auxiliary mode as follows:
●
If you own the A230E, A430E or A437E . . .
. . . press NUMBER key "0" or TV PROG. on the remote
control until "AU" appears on the recorder's front
display panel.
●
If you own the A233E, A237E or A433E . . .
. . . press NUMBER key "0" or TV PROG. on the remote
control until "AU2" appears on the recorder's front
display panel.
NOTE:
When connecting a satellite tuner together with a decoder . . .
. . . first connect the satellite tuner's output connector to the
decoder's input connector, then connect the decoder's
output connector to the recorder's AV2 IN or AV1 IN/OUT
connector (depending on the model of recorder you own).
TV Receiver
RF Cable
(provided)
TV Aerial
Cable
Decoder
AV1 IN/OUT
Back of Recorder
Satellite antenna
Satellite tuner
AV2 SELECT switch
AV2 IN (/DECODER)