Filter
Top Products
EN 27
EDITING
Audio dubbing replaces the audio sound of a previously
recorded tape with a new soundtrack.
Audio Dubbing
[E439EG only]
MAKE CONNECTIONS
1
Connect an audio component to the AUDIO IN
connector on the recorder's front panel.
SET INPUT MODE
2
Press NUMBER key "0". "F-AU" appears in place of a
channel number.
LOCATE START POINT
3
Press PLAY to start playback of the tape in your
recorder, and press PAUSE when you find the point
where you want to start dubbing.
ENGAGE AUDIO DUBBING
4
Press AUDIO DUBBING.
START DUBBING
5
Engage the audio component's Play mode, then press
PLAY to start the tape in your recorder. Audio dubbing
begins at this point.
● To stop dubbing temporarily, press PAUSE. Press
PLAY to resume dubbing.
END AUDIO DUBBING
6
Press STOP to stop the tape in your recorder, and
engage the audio component's Stop mode.
NOTES:
●
Audio dubbing stops automatically when the counter reaches
"0:00:00", and the recorder enters the Play mode. Check the
counter reading before dubbing.
●
Audio dubbing is also possible using the rear panel AV1 IN/
OUT or AV2 IN connector. When using these connectors,
make sure to select the correct input mode in step 2.
●
Connections made to the recorder's front panel are given
priority over those made to the rear panel connectors.
●
Audio dubbing cannot be performed on a cassette that has
had its record safety tab removed.
12
45
3
6
8
0
7
9
1
3
2
NUMBER "0"
AUDIO MONITOR
PLAY
PAUSE
+
–
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
CD Player
PLAY
PAUSE
AUDIO DUBBING