JVC HR-J261MS VCR User Manual


 
EN 29
Manual Channel Set
Store channels that were not stored during Auto Set Up ( pg. 6)
or Auto Channel Set ( pg. 28).
ACCESS TUNER SET
SCREEN
1
Perform steps 13 of "Auto Channel Set" on page 28.
ACCESS CHANNEL LIST
2
Press PUSH JOG
%
to place the pointer next to "CH
EDIT", then press OK or PUSH JOG .
SELECT POSITION
3
Press PUSH JOG
%
to place the pointer next to an
open channel position, then press OK or PUSH JOG .
SELECT BAND
4
Press PUSH JOG
%
to place the pointer next to the
band of your choice, then press OK to initiate Manual
Channel Set.
SET DESIRED STATION
5
The screen to the right
appears when a station is
detected.
If you do not want to store
the detected station...
Press PUSH JOG
%
to
place the pointer next to
"CONTINUE", then press
OK or PUSH JOG .
Channel search will resume.
If you want to store the detected station...
Press PUSH JOG
%
to place the pointer next to
"STORE", then press OK or PUSH JOG . The Channel
List appears again.
The blueback screen and the TV picture currently
being broadcast appear alternately for 8 seconds each.
If you want to store another channel, repeat steps 35.
When channel search completes for that band, the
Band Select screen appears again. To set channels for
other bands, select another band and start Manual
Channel Set again ( step 4 and 5).
For fine tuning adjustment, see "Fine-Tuning
Channels" on page 31.
RETURN TO NORMAL
SCREEN
6
Press MENU.
BAND SELECT
VHF L
VHF H
UHF
[5/
] =
[MENU] : EXIT
MANUAL CH SET
PLEASE WAIT
VHF L 100MHZ
[MENU] : EXIT
STORE
CONTINUE
[
5
/] =
[MENU] : EXIT
12 3
4
0
6
78
5
9
1
4
3
2
MENU
OK
PUSH JOG