Filter
Top Products
EN 35
3
¶
4¢
78
1
¡
1
2
3
456
7
8
0
9
CH
NUMBER
POWER
TV/VCR
MBR SET
STOP
SPECIAL FEATURES
TV Multi-Brand Remote
Control
The VCR's remote control can control several functions on JVC
remote control TVs and on the brands of remote control TVs
listed below. *The default setting is JVC code 01.
TURN ON THE TV
1
Turn the power on using the TV's remote control.
SET TV BRAND CODE
2
Refer to the chart below. While holding down TV on the
VCR's remote control, press MBR SET and enter your TV’s
brand code using the NUMBER keys, then press STOP.
Follow the example shown at bottom left.
● Once you have set the remote control to operate the
TV, you don’t have to repeat this step until you
replace your remote control’s batteries.
● PANASONIC has two codes. If the TV does not
function with one code, try entering the other.
OPERATE TV
3
First, while holding down TV, press POWER on the
remote to see if the TV’s power goes off as it should. If it
does, try other operations.
● The POWER, TV/VCR, CH
5
∞, TV VOL +/– and
NUMBER keys on the remote can all be used to
operate the TV. *For some brands of TV, you must
press ENTER after having pressed the NUMBER keys.
● To operate your TV, while holding down TV, press the
corresponding button: POWER, TV/VCR, CH
5
∞,
NUMBER keys (or ENTER). TV VOL +/– can be used
without holding down TV.
NOTE:
Depending on the type of TV, there may be cases where some
or all functions cannot be operated using the remote control.
TV
ENTER
TV VOL +/–
TV BRAND NAME BRAND CODE
JVC 01
MAGNAVOX 02
MITSUBISHI 03
PANASONIC 04, 11
RCA 05
SHARP 06
SONY 07
TOSHIBA 08
ZENITH 09
HITACHI 10
SAMSUNG 12
SANYO 13
SEARS 13
(Ex.) To set remote control to RCA 05:
Release
0
AUX
TV
5
7
STOP
MBR SET
Hold
down
Press in succession