Filter
Top Products
EN 23
¶
1
4¢
7
3
8
¡
123
456
7
8
0
9
2
1
3
NOTES:
●
You can programme this recorder to timer-record as many as
8 programmes. If you try to programme the recorder to record
a ninth, "PROGRAM FULL" appears on screen. To record the
extra programme, you must first cancel any unnecessary
programmes (
੬
pg. 26, "Check And Cancel Programmes").
●
In case of a power failure after programming, the recorder’s
memory backup keeps your selections (if the lithium battery
is not exhausted).
ATTENTION
Regarding Guide Program Number Set
"ERROR=GUIDE PROG" appears after performing step 3 on
the previous page if the Guide Program number for the
SHOWVIEW number you entered has not been set.
● If the recorder is in the stop or rewind or fast-forward
mode, the following screen will appear with "– –" under
"TV PROG" blinking.
• Press the NUMBER keys or PUSH JOG %fi to input the
channel position number you recorder receives that
station on, then press OK.
• Press MENU twice, then try again from step 1.
● If the recorder is in a mode other than the above mentioned
modes, press MENU first and input the correct Guide
Program number for that S
HOWVIEW number (੬ pg. 20,
"SHOWVIEW Setup"), then try again from step 1.
(Ex.) To timer-record a RTR
programme with SHOWVIEW
* If your recorder receives
RTR on the channel
position 2, press OK after
entering "2".
SHOWVIEW SET-UP
GUIDE PROG TV PROG
2– –
[0-9] OR [5/∞] : SELECT =
[MENU] : EXIT
NUMBER
OK
MENU
PUSH JOG