Filter
Top Products
Masterpage:Right-NoTitle0
EN
23
Filename [HRS6850EU1a.fm]
Page 23 April 12, 2001 9:59 am
Recording Features
Record One Programme While
Watching Another
If your recorder is connected to the TV via the AV
connection, press
TV/VCR
. The recorder’s VCR indicator
and the TV broadcast being recorded disappear. Once
recording is in progress, all you need to do is to set the
channel controls on the TV for the station you wish to
view.
● The programme selected with the TV’s channel controls
appears on the TV screen, while the one selected with the
recorder’s
PR
buttons is recorded on the tape.
● If a decoder is connected to the recorder (
੬
pg. 44), you can
select a scrambled channel as well with the TV channel
controls.
Instant Timer Recording (ITR)
This easy method lets you record for from 30 minutes to 6 hours
(selectable in 30-min. increments), and shuts the recorder off
after recording is finished.
1
Start recording.
Press
7
on the recorder.
2
Engage the ITR mode.
Press
7
again. “
o
” blinks and “0:30” appears on the front
display panel.
3
Set the recording duration.
If you want to record for more than 30 minutes, press
7
to extend the time. Each press extends recording time by
30 minutes.
NOTE:
You can only perform ITR using the
7
button on the recorder’s
front panel.
Elapsed Recording Time Indication
1
Set the counter display.
Press – –:– – until a counter reading appears on the front
display panel.
2
Reset the counter.
Press
0000
before starting recording or playback.
● The counter is reset to “0:00:00” and shows the exact elapsed
time as the tape runs. You can check the exact time of a
recording or playback.
Tape Remaining Time
Press – –:– – until the time remaining on the tape
appears.
● The front display panel shows the tape remaining time with
“
y
” displayed.
● By pressing the – –:– – button, you can change the display to
show the counter reading, channel position*, clock time or
tape remaining time.
* Channel position is not displayed during playback.
NOTE:
Depending on the type of tape being used, the tape remaining
time reading may not appear right away, or is not correct.
“– –:– –” may sometimes appear, or the display may blink on
occasion.
HRS6850EU1.book Page 23 Thursday, April 12, 2001 10:16 AM