Filter
Top Products
advanced features52
Editing Using Another VCR
connect up Connect the player’s 21-pin SCART connector to the recorder’s
21-pin SCART connector as illustrated.
A When using your VCR as the player ...
... connect its
AV1 (L-1) IN/OUT connector to another VCR.
B When using your VCR as the recorder ...
... connect its
AV2 (L-2) IN/DECODER or AV1 (L-1) IN/OUT connector to another
VCR.
set vcr’s input mode The recording VCR mode must be set to AUX. If this
VCR is the recorder, press
AUX and/or PR to select L-1 (if you’ve used the AV1 (L-1)
IN/OUT
connector) or L-2 (if you’ve used the AV2 (L-2) IN/DECODER connector). If
this VCR is the player, set
O.S.D. to OFF. (੬ pg.55)
• When using the
AV2 (L-2) IN/DECODER connector, set L-2 SELECT to the
appropriate mode. (੬ pg.51)
set edit mode See Picture Control on page33.
start source vcr Engage its PLAY mode.
start recording vcr Engage its RECORD mode.
NOTES:
• All necessary cables can be obtained from your dealer.
• For Y/C signal input/output, be sure to use a 21-pin SCART cable that is
compatible with the Y/C signal.
• When you set
PICTURE CONTROL to EDIT to dub tapes (੬ pg.33), be sure to
select
AUTO (or NORM when B.E.S.T. is set to OFF) after you finish dubbing the
tapes.
• If you are using another VCR with S-Video and Audio output connectors,
You can use you VCR as the recorder using an optional S-Video cable and
audio cable. Connect its front panel
S-VIDEO and AUDIO input connectors to
the source VCR’s S-Video and Audio output connectors. Then, set the VCR’s
input mode to
S-1.