Filter
Top Products
42 EN
123
456
7
89
0
2
4
1
3
TV Multi-Brand Remote
Control
The VCR's remote control can control several functions on JVC
remote control TVs and on the brands of remote control TVs
listed below. *The default setting is JVC code 01.
TURN ON THE TV
1
Turn the power on using the TV's remote control.
SET TV BRAND CODE
2
Refer to the chart in the left column. While holding down
TV on the VCR's remote control, press MBR SET and enter
your TV’s brand code using the NUMBER keys, then press
STOP.
Follow the example shown below.
Check if the TV's power goes off as it should. If it does,
try other operations (੬ step 3).
● Once you have set the remote control to operate the
TV, you don’t have to repeat this step until you
replace your remote control’s batteries.
● PANASONIC has two codes. If the TV does not
function with one code, try entering the other.
OPERATE TV
3
First, while holding down TV, press the corresponding
button: POWER, TV CH +/–, TV/VCR, TV VOL +/–,
NUMBER keys.
● For some brands of TV, you must press ENTER after
having pressed the NUMBER keys.
POWER
TV
NUMBER
TV/VCR
MBR SET
ENTER
TV VOL +/–
TV BRAND NAME BRAND CODE
JVC 01
MAGNAVOX 02
MITSUBISHI 03
PANASONIC 04, 11
RCA 05
SHARP 06
SONY 07
TOSHIBA 08
ZENITH 09
HITACHI 10
SAMSUNG 12
SANYO 13
SEARS 13
(Ex.) To set remote control to RCA 05:
Press in succession
TV
MBRSET
A/B
5
STOP
0
Hold
down
Release
NOTE:
Depending on the type of TV, there may be cases where some
or all functions cannot be operated using the remote control.
STOP
TV CH+/–
SPECIAL FEATURES