Filter
Top Products
Page 4 December 13, 2000 3:04 pm
Remote
On-screen display
If you press OSD on the Remote when “SUPERIMPOSE” is set to
“ON”, you can see the current VCR status on the TV screen. Press
OSD again to exit on-screen display.
The indications are not recorded even if the VCR is in the
recording mode.
A
Channel and auxiliary input
B
Day and clock time
C
STEREO program indication
D
SAP indication
E
Audio monitor indications
F
Time counter
G
Index number
H
Tape position
I
Cassette mark
J
Tape speed
K
VCR operation mode
Connections and
Plug&Play Setting
A
Check contents
Make sure the package contains all of the accessories listed in
“Specifications”.
B
Attach the 4 feet as illustrated below
If you place the VCR
vertically, attach the
wire clamp to hold the
AC power cord in
place as shown at
right.
C
Situate VCR
Place the VCR on a stable, horizontal surface. Do not place the
VCR in any other way than illustrated above.
D
Connect VCR to TV
RF Connection
A Disconnect the TV antenna from the TV.
B Connect the TV antenna cable to the ANT. IN terminal on the
rear of the VCR.
C Connect the supplied RF cable between the TV OUT terminal
on the rear of the VCR and the TV’s antenna input terminal.
AV Connection
(improves picture quality during tape playback.)
If your TV is equipped with audio/video input connectors
A Connect the antenna, VCR and TV as shown in the illustration.
B Connect an audio/video cable between the AUDIO/VIDEO
OUT connectors on the rear of the VCR and the audio/video
input connectors on the TV.
● Even if you are using audio/video cables to connect your VCR to
your TV, you must also connect it using the RF cable. This will
ensure that you can record one show while watching another.
Number keys
B
+++ E
CH125 RECORD
THU 12:00 AM PAUSE
STEREO SP
SAP
INDEX 1
NORM
HI-FI COUNT –1:23:45
Foot
If you want to place the VCR
vertically ...
Do not attach the foot on the
screw hole.
If you want to place the VCR
horizontally ...
Stick the wire clamp on the rear of the
VCR using the provided adhesive tape
with two sides.
Slide the AC power cord into the wire
clamp.
– Buttons, Connectors and Indicators –
HR-FS1U-EN.fm Page 4 Wednesday, December 13, 2000 3:04 PM